Quantity(Pieces) | 1 - 100 | >100 |
Est. Time(days) | 5 | To be negotiated |
High-pressure pump: It acts as a pressurizer to create a stable environment for the reverse osmosis membrane to work properly.
Low pressure switch: Prevent the pump from spinning. When the raw water pressure is lower than 0.03Mpa or the water is stopped, the low voltage automatically cuts off the power to stop the whole machine.
High pressure switch: Prevent the pump from running. When the pure water end of the gooseneck faucet is closed, the power is automatically cut off to stop the whole machine.
Inlet water solenoid valve: The function of turning on or cutting off raw water. Use pressure range ≤ 0.6Mpa.
Check valve: Also list the valve to control the direction of water flow.
Recoil solenoid valve: Automatically flush reverse osmosis membrane controlled by computer box.
Waste water proportionalizer: Control wastewater flow.
Transformer: convert 220V AC to DC (machine working safety voltage)
Model: | DF-TJ-1000 |
Power: | 168W |
Rated voltage/frequency: | AC110/60Hz |
Output Capacity: | 400-1600gallon/day |
Water pressure: | 0.1~0.5MPa |
Feed water temprature: | 5-40 °C |
Treatment Stages: | 5 stages |
Storage tank: | 11G tank |
filtration system: RO reverse osmosis technology
• control system: the indicator lamp control system
• washing way: every time you start 18 seconds automatic washing machine
• low voltage protection: water pressure is too low or when cut off the water supply, the system will automatically stop running
• high voltage protection: the system will automatically stop running pressure bucket is filled with water
Automatic replenishment: when the water storage bucket of water, the system will
automatically recharge
• noise: imported original parts, low noise, small vibration
Precautions:
(1) Never place the water purifier in a direct sunshine
(2) Move the machine carefully and lightly.
(3) The water purifier shall operate at a temperature of 5-42°c,,and must not filter hot water,otherwise this may cause damage;in winter,pay attention to heat preservation and protect against freeze.
(4) By using a cloth dipped in water,clean the water purifier with soft detergent rather that strong volatile solvent such as gasoline
(5) In case of failure,disconnect the water source promptly,and see the introduction or ask us.
(6) In case of Long-term no use.pull the power plug,close the feed ball valve and cut off the water source.
(7) In the cases where the water purifier is used for the first time or resued after long time idle
drain out the first two tanks of water through the goosennect tap after the tank is full,and then use the machine.
(8) Don’t use a power supply that does not match the related voltage