filtration system: RO reverse osmosis technology

• Waterway : Integration Type
• control system: the indicator lamp control system
• washing way: every time you start 18 seconds automatic washing machine
• low voltage protection: water pressure is too low or when cut off the water supply, the system will automatically stop running
• high voltage protection: the system will automatically stop running pressure bucket is filled with water
Automatic replenishment: when the water storage bucket of water, the system will automatically recharge
• noise: imported original parts, low noise, small vibration

1. The shell design is simple and elegant.
2. The machine has an anti-freeze alarm device.
3. The machine has a filter replacement reminder.
4. The waterway is upgraded to an integrated waterway.
5. With machine working status display.
6. The filter element adopts a snap-on filter element to eliminate waste of resources and the filter element housing can be reused.
7. Easy to install and fast.
8. The machine has a protector, and the protection solenoid valve is repeatedly washed and can be reused.
9. Can be placed at will.

Precautions:

(1) Never place the water purifier in a direct sunshine

(2) Move the machine carefully and lightly.

(3) The water purifier shall operate at a temperature of 5-42°c,,and must not filter hot water,otherwise this may cause damage;in winter,pay attention to heat preservation and

protect against freeze.

(4) By using a cloth dipped in water,clean the water purifier with soft detergent rather that strong

volatile solvent such as gasoline

(5) In case of failure,disconnect the water source promptly,and see the introduction or ask us.

(6) In case of Long-term no use.pull the power plug,close the feed ball valve and cut off the water

source.

(7) In the cases where the water purifier is used for the first time or resued after long time idle

drain out the first two tanks of water through the goosennect tap after the tank is full,and then

use the machine.

(8) Don’t use a power supply that does not match the related voltage