CERTIFICATE                                                                                     CERTIFICATE NO.

----------------------------------------------------------------------------------------------------------------------------------------------------------------------
CE                                                                                                        BCTC-2011009787-SZJR
CE                                                                                                        BCTC-2011009788-SZJR

PRODUCTS QUICK INFORMATION                                             DIM (MM)                                    MASS (KG)

----------------------------------------------------------------------------------------------------------------------------------------------------------------------

SMART SERIES                                                                                Φ250                                          1.1

                                             SMART SERIES                                                                                                    DIM DRAWING

PACKING INFORMATION

1. 302×302×110MM INNER BOX  2. 625×315×595MM OUTER BOX  3. EXPENDED PLASTIC COVER                           10 PCS / 1 OUTER BOX

INSTALLATION OR ASSEMBLY INSTRUCTIONS

PLEASE READ THESE INSTALLATION INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR MAINTAINING THIS
EQUIPMENT. THESE INSTRUCTIONS AND LOCAL REGULATIONS(WHERe APPLICABLE), BY AN AUTHORISED AND LICENCED ELECTRICIAN.

importANT – THE PRODUCT MUST BE MAINTAINED AND OPERATED IN ACCORDANCE WITH THE MANUFACTURE’S INSTRUCTIONS, FAILURE TO DO SO MAY DAMAGE THE PRODUCT AND SERVICES. IT IS STRonGLY RECOMMENDED THAT THIS importANT NOTE BE COMMUNICATED TO THE OWNER AND OR OPERATOR OF THE INSTALLATION AT THE TIME OF SITE COMMISSIONING. GOOD PRACTICE DOES NOT RECOMMEND THE 24/7 USE OF PRODUCTS WITHOUT THE APPLICATION OF SUITABLE SWITCH CYCLE INTERVALS. P&Q IS NOT RESPonSIBLE FOR ANY PRODUCT NOT MAINTAINED IN ACCORDANCE WITH THE RECOMMENDED PROCEDURES. ALL PRODUCTS SHOULD BE THOROUGHLY CLEANED ON A REGULAR BASIS TO ENSURE THE OPTICAL PERFORMANCE, TOGETHER WITH THE ELECTRICAL,MECHANICAL AND STRUCTURAL INTEGRITY AS DESIGNED, IS MAINTAINED THROUGHOUT THE SERVICE LIFE OF THE PRODUCT.

“ConSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR”

1. PRODUCT SPECIFICATION:

2. STORAGE: PRIOR TO INSTALLATION PRODUCTS ARE TO BE STORED IN COOL AND DRY CONDITIONS.

3. INSTALLATION DRAWINGS

STEP 1: TAKE OFF THE ENCLOSER AND ORIGINAL SOURCE OF THE CEILING LIGHT.
STEP 2: WIRING.
STEP 3: INSTALL NEW SOURCE.
STEP 4: INSTALL THE ENCLOSER BACK.

4. ELECTRICAL FAULT FINDING AND RELACEMENT:
THE SUPPLY MUST BE ISOLATED BEFORE OPENING THE LUMINAIRE. IF ALL ConNECTIONS ARE VERIFIED TO BE CORRECT, THE PRODUCTS ENVIRonMENT MAY BE HAVINg AN ADVERSE EFFECT TO THE COMPONENTS. IF THIS IS THE CASE PLEASE ConTACT YOUR SUPPLIER FOR A MORE SUITABLE REPLACEMENT. ANY FAULT FINDING MUST BE DONE BY A FULLY QUALIFIED ELECTRICIAN AND, IF CARRIED OUT WITH THE LUMINAIRE IN PLACE, UNDER A PERMIT TO WORK. WITH REPLACEMENT OF ANY PART ENSURE THAT WIRES AND ConNECTIONS ARE CHECKED, AND ANY WIRE SLEEVING REFITTED. FOR SHOCKPROOF IK10 ROUND CEILING LIGHT.