HX-SZ600-WP86-RGBW

LED RGBW controller with RF wireless full touch wall panel

HX-SZ600-WP86-RGBW, adopts the most advanced PWM (Pulse Width Modulation) digital control technology, it is used for controlling constant voltage LED RGBW lamps. For instance, point source of light, flexible light strip, led modules, led strings and so on; It belongs to low-voltage DC power input and output with four interfaces, including + V is extremely common interfaces, the other four for the RGBW control interface. Meanwhile, you could adjust brightness, static color choices and various dynamic changes in lighting effects through full-touch wall panel remote control. In addition, It is convenient to use RJ45 connector to connect the multiple controllers together, and achieve the synchronization function of thousands meters led strips. In theory, they can be connected numerous.

Product Features

l  Designed for RGB constant voltage LED lights, Working voltage DC12-24V.

l  Three channels output, Max. load current: 4CH*8A; Max. load power: 384W/12V; 768W/24V.

l  Adopts full-touch wall panel remote control with fashion appearance, no need line-of-sight. Control range up to 20 meters. The working voltage of wall-panel is AC90-265V.

l  Structure/dimension/installation of the wall panel according to the 86-type European standards.

l  Memory function, each time power-on reserve the mode which stop in the last power-down.

l  The brightness of static color is adjustable, 256 levels in total; the speed of dynamic changes is adjustable, 100 levels in total.

l  Long-press the brightness and speed key can get the fast adjustment, convenient for operation.

l  Multiple controllers can work synchronically when connected by network cable through the RJ45 connector, the network cable between 2 ports up to 80 meters.

l  Warranty of this product is one year, exclude the artificial situation of damaged or overload working.

Technical Parameters

Controller

Remote control

Interface Specifications

Direction for use

l  Connect the load wire at first, followed by the power wire; Please ensure short circuit can not occur between wires before turning on the power;

l  Adopts RF full touch wall-panel remote control, with one color ring and 5 function buttons.

l  The signal light flash-- represents the signal has been sent well;

The function of buttons are shown as below:

The function of each button as below:

9 modes in total as below:

Tips: Receiver can be controlled by any one the same remote as factory default; the wall-panel remote control delivered with unique RF code as factory default; if unique-control is needed, please matching the code before installation and using.

Matching code operation

If unique-control or new-coded-remote is needed, pairing the remote and the receiver as below operation instruction before using:

1. Step 1: Pressing key “mode”and hold on, power on the controller, the load LEDs will be 50% brightness white as responding.
2. Step 2: Continuously to press the key “W ONOFF“ for 3 times within 5 seconds after step 1 ,the brightness of LEDs will change from 25% -10% as responding.
3. Code learning successfully, the LEDs will be back to the status before the power off, and the receiver only can be control by the remote.
4. If not, please re-operate from step 1 to 2.

Wall-panel Installation instruction