Huizhou water cooler peltier foam cooler tec chiller tec cooler

Product  Note

1, When use self-tapping screws to work with water cooler, must avoid the melt surface ice at the bottom of the gallbladder, otherwise, once the self tapping screw twist into the melt surface, can cause leakage phenomenon. Melt surface position dimensions as shown in figure (ice bile installed at the bottom of the aperture Φ2.5 or 3.0 Φ; fixed screw choose 4 x 12 ba tapping screw).

2, The center of the water cooler vents must be at the center of the backboard of the water fountain, the fan side of the water   is 96mm high.

3,Don't make the fan of water cooler cover water machine back contact directly, and must be set by the fan cover and add a rubber horn ring or sponge coil and water cooler back contact.

4, All the silicone tube, set into the water cooler inlet and outlet pipe, drainage pipe, must be fitting, and sets of not less than 10 mm in length, and nylon cable tie or card to lock ring (note: silicone tube before assembly, application of boiling water for 30 minutes).

Connection diagram 

               Pre-sales service                                                          After-Sales Service

               *Inquiy and consulting support                                     *Training how to instal the machine

               *Sample testing support                                               * Training how to use the machine

               * View our Factory

Product process

Packing&Delivery

      Packaging : Carton box or customized

                   Delivery time: Two weeks

   For more information,please feel free to contact with me !