No.

Model

Rated airflow

(m³/h)

Rated power

(W)

cooling capacity

(kW)

Energy efficiency ratio

1

SLXF-03

3000

450

9.10

20.1

2

SLXF-05

5000

750

15.08

20.1

3

SLXF-10

10000

1360

29.38

21.6

4

SLXF-15

15000

2000

42.42

21.2

5

SLXF-18

18000

2400

48.96

20.4

No.

Comparison project

Hop Evaporation cooling ventilation

Other companies

Remark

1

Using filters.

Automatically detect filtration cotton to be clogged or not and replace clogged cotton

Artificially replace the flat filter .

Automatically detect filtration cotton is clogged or not , automatically replacement it if filtration cotton clogged

2

Wet-film number

3-4 side wet-film, evaporation area has expanded 3-4 times

One side wet-film, evaporation area is small

Evaporated air intake efficiency improve to 50 % to 75% .

4

Using fan

Centrifugal fan, high wind pressure , maximum wind speed reaches 25m / s

Axial fan ,low air pressure, maximum wind speed does not exceed 15m / s

High air pressure ,send air to long distance .

5

Quiet design

Quiet isolation unique design, indoor noise below 65dB, outdoor noise less than 70dB

Indoor noise below 70dB, outdoor noise less than 75dB

When the room is in a residential area or office area, should prevent noise nuisance.

6

Water way design

The embedded water distribution system , prevent water to be sucked in room because of aging water pipes , ruptured water pipes

Use exposed pipes, pipe joints or pipes burst after aging , water droplets are inhaled room

prevent water to be sucked in room because of aging water pipes , ruptured water pipes

7

Automatic cleaning function

Automatic cleaning interval can be set according to the local water and air pollution

Can not be based on water and air pollution flexible settings

Can be timed to discharge dirty water .

8

Air conditioning linkage

When the outdoor temperature higher than the set value, Evaporation cooling ventilation to stop working, then the controller will start the engine room air conditioner

Simultaneous activation of multiple air conditioners

Room temperature conditions can be flexibly adjusted according to the using

9

variable speed motor

According indoor’s and indoor’s temperature , fan speed through frequency conversion adjust the speed , reducing fan consumption

No frequency control section

Can do fine energy saving, avoid unnecessary energy consumption

10

Backup temperature and humidity sensor

100 square meters below room temperature and humidity sensor detection point of not less than three ( near, middle and far ) , 100 square meters above room temperature and humidity sensor detects the point of not less than five ( installation position refer to the installation specification ).The controller uses the average value of sensor’s data

Only a maximum of two indoor temperature and humidity sensor

If any sensor fails, the system will automatically identify and remove wrong sensor, and then averaging the remaining sensor’s data