1. The micro-computer controller has been made adjustment for temperature, humidity, egg-turing, exhaust, etc. before leaving factory, which meets settings required by incubation. Under normal circumstances, you do not need to set up and may use it by connecting the power supply. Factory settings: temperature 38°C, humidity 60% RH; cycle of egg-turning: 90-minute, time of egg-turning: 180 seconds; ventilation cycle: 120 minutes; ventilation time: 30 seconds; egg-turning state: automatic egg-turning.

2. If you need only to change the temperature and humidity parameters, please refer to Section III in page 2 of this Manual. Please do not set up other parameters in order to avoid operation errors which may affect your usage and bring you f unnecessary losses.

3.Temperature and humidity sensors are made of high precise and micro-molecular materials, please do not make the sensor come into contact with the water directly. The dust must be regularly cleared on the surface of the sensor, or it will affect the measurement accuracy.

4.The manufacturer should only assume the obligation for products selled to users, but not undertake users’ other losses caused by product failure.

Technology Parameters

key function introduce:

1.Digital temperature control---can be adjusted between 20-50  centigrade degree and provide a constant temperature incubating environment. 

2.The power switch is located in front panel of the incubator. During the incubating, you are free to open or close the incubator. 

3.Egg traycan be automatic to turn the eggs after you contact the motor line and controller line.

4.At the bottom of the channel keep wet for the incubation process, Machine configuration with a kettle and cork, and you can add water through External hole to increase the humidity. It’s better to add the warm 

CE certification:

Contact us: