outdoor custom adhesive waterproof sealing tape
PRODUCT INTRODUCTION
bitumen waterproof seal bitumen tape is a kind of polymer modified asphalt materials, using polyester carpet or glass mat for the matrix, the surface covered with polyethylene film, aluminum foil or fine sand, the back is covered with a release sheet,keep the self adhesive modified bitumen flexible and waterproof. The product has a good self-adhesive and bending properties.
Thickness: 1mm, 1.2mm, 1.5mm, 2mm, 2.5mm, 3mm, 4mm
Width: 1m or any wide with 1m(that's mean we can cut into any rolls)
Length: 10m, 15m, 20m, 25m
Reinforcement: polyester, fiberglass or without anything
No
| Item | I | II |
PY | G | PY | G |
1 | Soluble content (g/m2)≥ | 3mm | 2100 |
4mm | 2900 |
5mm | 3500 |
Test | No flame | No flame |
2 | Heat resistance | ºC | 90 | 105 |
≤mm | 2 |
Test | No flow no dropping |
3 | Low temperature flexibilityºC | -20 | -25 |
No crack |
4 | Impermeability 30 minutes | 0.3Mpa | 0.2Mpa | 0.3Mpa |
5 | Tension | Maximum (N/50mm)≥ | 500 | 350 | 800 | 500 |
Secondly-Maximum(N/50mm)≥ | | | | 800 |
Test
| No crack no apart |
6 | Elongation | Maximum %≥ | 30 | | 40 | |
Secondly-Maximum %≥
| | | | 15 |
7 | Oil leaking | Pieces ≤ | 2 |
Features:
SBS polymer provides flow resisitance at high temperatures and flexibility at low temperatures for lasting durability.
Non-woven polyester 180g/m2 reinforcement.
Designed for application in new construction,re-roofing and retrofit roofing.
Excellent tear resistance.
Surface:
1.PE
2.Colorful Sand
3.Schist
4.Aluminum Foil
PRODUCT PICTURES
Make sure the roof deck smooth,clean,and dry (moisture<9%),then apply the surface of roof deck homogeneously with a kind bitumen paint,till dry to start application.
There are two methods in application.
One way is by heating and melting method.Heat the polyethylene film of the membrane and roof deck surface by heating and melting method to be nearly melted(not flowing),then install the membrane fully bonded to the roof deck with overlaps of 5-10cm.
The other way is by cold adhesive method.Pour the cold adhesive homogeneously on the roof deck,then roll the membrane to install it to be fully sticked to roof deck.
By heating and melting method and by cold adhesive can be used in alternation in application as requested.
After application,a full serious inspection is required to sure no air bubble,no fold,no falling away.ect. To guarantee the waterproof life.
Construction and other base face is simple, clean, and can be widely used in roofing, basement, bathroom, etc. waterproofing works, and for legislation to pave and stick and pipe wall (except heat pipes), bridges , and other complex environment, especially in open flame is prohibited, covert fire waterproofing works.